![]() Artificial logs or paper log rolls should be used one at a time to prevent large volumes of smoke. Fire Starters + Resinous Wood: Not intended to be used with used with resinous woods.Complete, Longer Burns: This variable speed fan ensures fires won’t snuff out due to lack of draft, resulting in less coal or wood use.Keep fires going longer with less coal or wood usage with the Tjernlund AUTO-DRAFT Stove Blower. ETL-Certification: Designed for safety, this fan carries an ETL-Intertek certification.Fuel Utilization: Sufficient airflow maximizes coal and wood fuel, reducing to a fine ash.Limited Amps: The fan motor only pulls one-amp of power.Reduces Backdraft: Eliminate smoke that creeps into the room with the powerful 1,200 – 1,600 RPM fan.Sealed Motor Housing: The sealed motor never needs to be oiled.Minimal Maintenance: Remove once per year to clean and remove soot build-up inside fan wheel and housing.Heavy-Duty Construction: Flat black, heat resistant finish, so it won’t destroy the paint finish.Easy Install: Install horizontally, vertically, or on an inclined five to eight-inch diameter pipe in a matter of minutes. If a wood burning stove has an automatic draft regulator controlled by a thermostat, the manufacturers instructions for installing it must be carefully.This solid fuel furnace can be the primary heater for the home or commercial building or add on to. Switch on the low to high variable speed fan control to generate an automatic draft for lighting hard-starting stoves and a broad range of fuels, including coal and moist wood.įor quick installation, the included rectangular template makes it easy to effortlessly mount the blower housing and motor. Glenwood Commercial, Industrial Quality Wood Furnace. The wood length is approximately 20 and requires seasoned wood that has an 18-28 moisture content. Mount one to two feet above the stove on the stove pipe using the included 3 1/8 W x 8 5/8 H-inch template and screws. The EPA Phase 2 certified Kuuma Vapor-Fire 100 is our largest Vapor-Fire wood-burning furnace. The Tjernlund Stove Blower immediately pulls adequate air supply to help ignite wood burning or coal burning stoves while reducing smoke backdrafts. With a 15-minute install time, can be hardwired onto any 115-volt AC circuit and the entire motor removes for easy cleaning. Designed for any five to eight-inch diameter pipe, it lights any hard-lighting wood burning or coal stoves with a broad range of fuels without adding height or diameter to the chimney pipe. ![]() Adjust fan speed with the variable speed control knob to light and maintain fire flames. The hardwired Tjernlund AD-1 makes building and maintaining a fire inside any wood or coal burning stove easier.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |